Referring to the instructions, check whether the paper is in place on the right side of the printer. With paper fed into the bin, still no paper is detected on the screen. ⑥ Press Power button for 2 sec to turn on the printer, press feed button to push one piece of plate. ⑤ Pull out the paper （Raise the paper out of the paper bin by approximately 15mm ) and close the paper cover, make sure the paper bin is closed. ④ Aim the adjustable plate at both slots and slowly put into the paper bin. ③ Put in the paper roll (The print side should be below and push it to the right）Dividing ruler should be above Note the position of the paper roll device as shown. ② Take out the adjustable plate and remove the left panel. ① Press the “open” button gently to open the paper bin. Thermosensitive label ,thermosensitive continuous paper No paper in the bin or paper is installed incorrectly Interstitial paper, continuous paper, Black mark labelĥmin, 15min, 30min, 1h, 2h, 4h, 8h, 24h, No shutdown Please charge your printer when the power display begins to flash.
It will light up when the printer is connected to a power source. It will light up while the printer is printing or feeding. When the paper is detected, it will give you a confirmation so that you are able to proceed. If the paper roll is not installed correctly, or there is insufficient paper, this logo will light up message will appear, stating that there no paper. It indicates that the paper cover is opened or not closed correctly, message will appear, stating that the paper cover is opened. When you are using USB wire, this logo will be shown as: If you press Power Button for a short time, it will be switched to Setting Mode, the logo will be shown as Setting Mode. This logo will flash when the data is transferring. When printer connects to Bluetooth, this logo will light up. ④ Restore factory settings: press the key to enter the home page to select restore factory settings, then press the paper key to complete the“ restore factory settings”. ③ Press Power Button for 2 seconds to go back to the main page. ② Press Feed Button for 1 second scroll option list and select, by pressing Power Button. ③ Press Power Button for 1.5 seconds to go back to the main page. ② Press Feed Button for second, scroll option list and select by pressing Power Button.
① Press Power Button for 1 second to switch to the setting interface. ② Continuous paper: Press Feed Button to keep paper feeding it will stop when you let go of the button. ① Label paper /Blackmark label: Press Feed Button to feed the tape to the proper place and get ready for printing next tape. ② To turn it off, please press the Power Button for 1.5 seconds. ① Press Power Button for 1.5 seconds to turn on the printer. Please read this Instruction carefully before using this product and keep it properly.
0 kommentar(er)
